 |
| |
| |
 |
| |
| |
| FIRE RETARDING POLYPROPYLEN |
Thermal plastic with a weight mass of approx. 0.98 grams/cm
3.
Suitable for use in fire hazard areas, as microwave ovens
and the like.
Temperature range from + 5°C to + 120°C
High chemical resistance.
Flammability VO (3.2 mm).
FDA approved.
Strong material with medium tensile strength.
Low impact strength at low temperatures. |
|
| |
| |
| FRICTION MATERIAL |
Thermal plastic with a weight mass of approx. 1.14 grams/cm
3.
Suitable for use in both warm and cold areas.
Temperature range from - 25°C to + 80°C.
High chemical resistance.
FDA approved.
Soft material with high friction, low tensile strength.
Suitable to put on the surface of PE and PP belts.
Used for belts with slight inclination. |
|
| |
| |
| NYLON 6 |
Thermal plastic with a weight mass of approx. 1.08 grams/cm
3.
Suitable for use in both warm and cold areas.
Temperature range from - 45°C to + 110°C.
High chemical resistance.
Not suitable in damp areas at high temperatures.
FDA approved.
Tough yet flexible material with high tensile strength as well as
high impact strength.
|
|
| |
| |
| NYLON 6.6 |
Thermal plastic with a weight mass of approx. 1.1 grams/cm
3.
Suitable for use in both warm and cold areas.
Temperature range from - 45°C to + 150°C.
High chemical resistance, though not suitable for use in very
damp areas at high temperatures
Tough yet flexible material with high tensile strength
as well as high impact strength.
|
|
| |
| |
| NYLON ANTISTATIC |
Thermal plastic with a weight mass of 1.1 grams/cm
3.
Suitable for use where electrical diversion is required.
Temperature range from - 45°C to + 110°C.
High chemical resistance.
Not suitable in wet areas
Tough yet flexible material with high tensile strength as well as
high impact strength.
|
|
| |
| |
 |
| |
| |
| |
| |
| |
| |
| |
| |
| |
This page is
best viewed at a resolution of |
| |
 with
|
|
| |
| |
Copyright
© 2000 by P.B.A. Industrial Supplies Ltd and
Scanbelt A/S
| |
|
|
